Engine Support, Removing And Installing: Installing
WARNING: This page is about a different variant/trim than selected.
Install in reverse order of removal and note the following:
-- Install the engine mount. Refer to ENGINE MOUNT, REMOVING AND INSTALLING .
Engine Support - Tightening Sequence
NOTE:
Replace the bolts.
-- Tighten the bolts in the steps shown in the sequence:
| Step | Screws | Tightening Specification/Additional Turn |
|---|---|---|
| 1. | -1 to 3- | 7 Nm |
| 2. | -1 to 3- | 40 Nm |
| 3. | -1 to 3- | 90° additional turn |