Seal Between Bevel Box And Manual Transmission, Replacing On Bevel Box

Special tools and workshop equipment required 

• Puller - Crankshaft/Power Steering Seal: T20143 
• Seal Installer - Bevel Box: T10298 
• Sealing Grease
• Refer to the Parts Information for the grease allocation.

-- Remove the bevel box. Refer to BEVEL BOX, REMOVING .

-- Pry out the seal using the : T20143/1  or : T20143/2  .

Fig 1: Identifying Pulling Hook T20143/1 Or T20143/2 To Pry Out Sealing Ring On Bevel Box

Courtesy of VOLKSWAGEN GROUP OF AMERICA, INC.

-- Fill the space between the sealing lip and dust lip -arrow- halfway with Sealing Grease.

Fig 2: Identifying Oil Seal

Courtesy of VOLKSWAGEN GROUP OF AMERICA, INC.

-- Lightly oil the outer edge of the new seal.

-- Install the seal all the way.

Fig 3: Driving In Sealing Ring As Far As Stop Using Thrust Piece T10298

Courtesy of VOLKSWAGEN GROUP OF AMERICA, INC.

-- Install the bevel box. Refer to BEVEL BOX, INSTALLING .

-- Check the level of the gear oil inside the bevel box. Refer to the appropriate Service Information .

-- Check the transmission fluid level in the manual transmission. Refer to TRANSMISSION FLUID LEVEL, CHECKING .