Adjustment Overview

WARNING: This page is about a different variant/trim than selected.

NOTE:

When performing repairs on the transmission, readjustment of the output shaft for 1st to 4th gears, output shaft for 5th/6th gear and reverse gears or differential is only required if components, which have a direct influence on transmission adjustment, have been replaced. Note the following table to avoid unnecessary adjustments:

		To be adjusted:
		1st to 4th gear output shaft. Refer to OUTPUT SHAFT, ADJUSTING .	5th/6th and reverse gear output shaft. Refer to 5TH/6TH AND REVERSE GEAR OUTPUT SHAFT, ADJUSTING .	Differential. Refer to DIFFERENTIAL, ADJUSTING .
Replaced part:	Transmission Housing	x	x	x
	Clutch Housing	x	x	x
	1st through 4th Gear Output Shaft	x
	5th, 6th and Reverse Gear Output Shaft		x
	Differential			x
	Tapered roller bearing for 1st to 4th gear output shaft	x
	Tapered roller bearing for 5th/6th and reverse gear output shaft		x
	Differential tapered roller bearing			x