Selector Shaft Seal, Replacing

WARNING: This page is about a different variant/trim than selected.

Special tools and workshop equipment required

-- Remove the gearshift lever and selector relay lever. Refer to OVERVIEW - SHIFT MECHANISM .

NOTE:

If it is not possible to remove the selector relay lever through the transmission bracket, then remove the sliding shoe from the gearshift lever.

-- Remove the gearshift lever from the gearshift shaft.

-- Remove the seal using the : T20143/1

Fig 1: Identifying Pulling Hook T20143/1 To Pry Out Seal

Courtesy of VOLKSWAGEN GROUP OF AMERICA, INC.

-- Lightly oil the outer edge of the new seal.

Fig 2: Identifying Oil Seal

Courtesy of VOLKSWAGEN GROUP OF AMERICA, INC.

-- Fill the area between the sealing lip and dust lip -arrow- halfway with Sealing Grease.

-- Drive in the seal using the : VW423 .

Fig 3: Driving In Sealing Ring As Far As Stop Using Sleeve VW 423

Courtesy of VOLKSWAGEN GROUP OF AMERICA, INC.

-- Install the gearshift lever and selector relay lever. Refer to OVERVIEW - SHIFT MECHANISM .