Bevel Box Or Front Axle Differential Lock, Securing To Engine And Transmission Holder

WARNING: This page is about a different variant/trim than selected.

Special tools and workshop equipment required

-- Mount the bevel box or front axle differential lock on the hole marked with the number -4- -arrow- in the : T10108 .

Fig 1: Identifying Bevel Box Set On Hole Designated With Number 4 In Gearbox Support T10108

Courtesy of VOLKSWAGEN GROUP OF AMERICA, INC.

A - Insert the M12 x 10 nut (quantity: 4) between bevel box and Transmission Holder.

-- Then align bevel box or front axle differential lock to the remaining 3 holes and secure.