Left Seal, Replacing: Installing
WARNING: This page is about a different variant/trim than selected.
Install in reverse order of removal. Note the following:
Before installing, coat the sealing lips of the seal and the spaces between them with Radial Shaft Seal Sealing Grease and the outer edge with oil.
- Installation position: open side of the seal faces the transmission.
-- Immediately mount the seal by hand and push it in as far as possible so that it is secure in the transmission housing.
-- Install the seal all the way using the : T10457 . Do not tilt the seal.
-- Install the left drive axle. Refer to DRIVE AXLE, REMOVING AND INSTALLING .
-- Check and fill the transmission fluid level. Refer to TRANSMISSION FLUID .