Right Seal On Outer Front Axle Differential Lock, Replacing: Installing

Fig 1: Install Flange Shaft Seal.

Courtesy of VOLKSWAGEN GROUP OF AMERICA, INC.

-- Lightly oil the outer edge of the new seal.

-- Install the seal all the way without tilting it.

-- Fill the area between the sealing lip and dust lip -arrow- halfway with Sealing Grease.

Fig 2: Identifying Oil Seal

Courtesy of VOLKSWAGEN GROUP OF AMERICA, INC.

Replacing the Circlip arrow

Fig 3: Flange Shaft To Slide Hammer Set VW771

Courtesy of VOLKSWAGEN GROUP OF AMERICA, INC.

-- Press in the flange shaft all the way by hand.

-- Carefully drive in the flange shaft without tilting.

-- Tighten the flange shaft with a bolt.

-- Fill the front axle differential lock. Refer to FRONT AXLE DIFFERENTIAL LOCK FLUID, DRAINING AND FILLING .

Install in reverse order of removal. Note the following:

-- Install the right drive axle. Refer to DRIVE AXLE, REMOVING AND INSTALLING .

-- Install the drive axle heat shield -arrows-. Refer DRIVE AXLE HEAT SHIELD, REMOVING AND INSTALLING to .

Courtesy of VOLKSWAGEN GROUP OF AMERICA, INC.

-- Install the noise insulation. Refer to OVERVIEW - NOISE INSULATION .