LEMON Manuals: Even more car manuals for everyone
Home >> Volkswagen >> 2021 >> Jetta S, Standard Trans >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 23 (Final Drive, Differential (0GC)) >> 39 Final Drive, Differential >> Front Axle Differential Lock Components >> Front Axle Differential Lock Seals, Replacing >> Right Flange Shaft Seal In Front Axle Differential Lock, Replacing >> Removing

Right Flange Shaft Seal In Front Axle Differential Lock, Replacing: Removing

WARNING: This page is about a different variant/trim than selected.

-- Remove front axle differential lock FRONT AXLE DIFFERENTIAL LOCK, REMOVING .

-- Secure the front axle differential lock to the engine and transmission holder. Refer to FRONT AXLE DIFFERENTIAL LOCK, SECURING TO ENGINE AND TRANSMISSION HOLDER .

-- Remove the flange shaft Figure.

The Seal Is Located in the Front Axle Differential Lock in Front of the Roller Bearing -A-.

Fig 1: Slide Hammer Set VW771 With Slide Hammer Set - Hook VW771/37
GWWN39-10787Courtesy of VOLKSWAGEN GROUP OF AMERICA, INC.
CAUTION:

Risk of damaging the roller bearing

- Do not damage the roller bearing -A- when removing the seal.

- Seal installation position: 105 mm under the upper edge/hollow shaft

-- Pull out the seal using the Slide Hammer Set: VW771  with Slide Hammer Set - Hook: VW771/37  .