LEMON Manuals: Even more car manuals for everyone
Home >> Volkswagen >> 2021 >> Jetta S, Standard Trans >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 22 (Controls, Housing (0GC)) >> 34 Controls, Housing >> Transmission Fluid Circuit >> ENGINE FOR Transmission Fluid Auxiliary Hydraulic Pump 1 - V475-, REMOVING AND INSTALLING >> Removing

ENGINE FOR Transmission Fluid Auxiliary Hydraulic Pump 1 - V475-, REMOVING AND INSTALLING: Removing

WARNING: This page is about a different variant/trim than selected.

-- Drain the transmission fluid. Refer to TRANSMISSION FLUID, DRAINING AND FILLING .

-- Vehicles with front axle differential lock: remove the front axle differential lock. Refer to FRONT AXLE DIFFERENTIAL LOCK, REMOVING .

-- Vehicles without front axle differential lock: remove the right drive axle from the transmission. Refer to DRIVE AXLE, REMOVING AND INSTALLING .

-- Release the connector for the Transmission Fluid Auxiliary Hydraulic Pump 1 -V475- -a- and remove the connector -b-.

GWWN34-12490Courtesy of VOLKSWAGEN GROUP OF AMERICA, INC.

-- Remove the bolts -arrows-.

GWWA34-11634Courtesy of VOLKSWAGEN GROUP OF AMERICA, INC.

-- Guide the : T10530  in hole.

GWWA34-11635Courtesy of VOLKSWAGEN GROUP OF AMERICA, INC.

-- Turn the knurled nut -2- clockwise until the puller clamps.

-- Using the : T10530  carefully remove the pump motor horizontally to the side.