Clutch, Removing And Installing, With Dual Mass Flywheel, SACHS: Removing

Fig 1: Identifying Stop & Pin

Courtesy of VOLKSWAGEN GROUP OF AMERICA, INC.

• The transmission is removed.

-- Insert the : 3067  to loosen the bolts.

When Removing, Loosen the Clutch Pressure Plate as Follows so That the Pressure Plate Does Not Distort (Causing Shuddering on Acceleration):

-- Loosen all bolts diagonally in small steps.

• When loosening, the stop -2- and the bolt -1- must loosen up together.

-- If the stop does not loosen: push the bolt toward the dual mass flywheel.

-- Remove the pressure plate and the clutch plate.