Clutch Slave Cylinder With Release Bearing, Removing And Installing: Installing

WARNING: This page is about a different variant/trim than selected.

Install in the reverse order of removal while noting the following:

Otherwise, there is the danger that the tabs with the fastening holes could break off.

-- Check the O-ring -3- on the clutch slave cylinder for damage.

Fig 1: Bleeder At Slave Cylinder, Removal/Installation

Courtesy of VOLKSWAGEN GROUP OF AMERICA, INC.

-- Push the bleeder -4- onto the clutch slave cylinder connection -1- until the clip -2- clicks into place.

-- To check, pull on the bleeder.

-- Install the transmission. Refer to TRANSMISSION, INSTALLING .

-- Bleed the clutch mechanism. Refer to CLUTCH MECHANISM, BLEEDING .