LEMON Manuals: Even more car manuals for everyone
Home >> Volkswagen >> 2021 >> Jetta S, Standard Trans >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 14 (Exhaust System, Emission Controls [DKFA,CXDB]) >> 26 Exhaust System, Emission Controls >> Exhaust Pipes/Mufflers >> Clamping Sleeve Installation Position >> Tightening Specification Of The Clamping Sleeve

Tightening Specification Of The Clamping Sleeve

WARNING: This page is about a different variant/trim than selected.
Fig 1: Identifying Tightening Torque And Installed Dimension Of Clamping Sleeve
GWWN26-10627Courtesy of VOLKSWAGEN GROUP OF AMERICA, INC.
Clamping Sleeve Tightening Specification
Clamping sleeve -A- with two individual clamps 25 Nm
Clamping sleeve -B- with continuous clamp. 30 Nm

Tighten the threaded connections evenly.

scientia non olet · About LEMON Manuals