Charge Air Pressure Actuator -V465-, ADJUSTING

WARNING: This page is about a different variant/trim than selected.

Special tools and workshop equipment required

Removing

-- Remove the bolt -2- and the screw-type clamp.

Fig 1: Catalytic Converter - Tightening Sequence

Courtesy of VOLKSWAGEN GROUP OF AMERICA, INC.

-- Remove the noise insulation. Refer to OVERVIEW - NOISE INSULATION .

-- Remove the nuts -1 and 3-.

NOTE:

Ignore -4-.

-- Remove bolts -arrows- and set the catalytic converter slightly aside.

Fig 2: Identifying Exhaust System Bracket (Suspended Mount) Bolts

Courtesy of VOLKSWAGEN GROUP OF AMERICA, INC.

-- Turn on the ignition and select the following menu items on the Vehicle Diagnostic Tester:

-- Adjust the charge air pressure actuator linkage to the instructions in the vehicle diagnostic tester.

-- Tighten the lock nut with the : VAS6854 .

Tightening Specifications