Oil Separator, Removing And Installing: Removing

-- Disconnect the connectors from the ignition coil and remove them from the ignition coils at the same time.

-- Remove the bolts from the ignition coils "3 and 4" and remove the ignition coils.

-- Loosen the hose clamp -1- and remove the hose from the EVAP Canister Purge Regulator Valve 1 -N80-.

Fig 1: Locating Oil Separator Bolts

Courtesy of VOLKSWAGEN GROUP OF AMERICA, INC.

-- Remove the bolt -2- and then remove the crankcase ventilation hose -3- from oil separator.

-- Remove the bolts -arrows- and the oil separator.