Adapter For Assembling Flushing Circuit: Notes
-- The desiccant bag or dryer cartridge must always be removed before every flushing. Then reseal the receiver/dryer.
-- If the condenser has a permanently installed dryer, it can also be flushed. Then a new condenser must be installed.
NOTE:
If a flushed refrigerant circuit is not reassembled immediately after the flushing procedure, then the adapters must be left on the connections and seal the components that are still open with clean plugs from the Engine Bung Set :VAS6122
After Completing the Flushing Procedure Successfully, Reassemble All Adapters and Replace the Following Components During Assembly:
- A/C compressor (only after replacing the A/C compressor, due to internal damage),
- Restrictor or expansion valve.
- Desiccant bag or dryer cartridge,
- High and low pressure side evacuating and charging valves,
- Seals.