Reducing Agent Delivery Module, Removing And Installing: Installing

WARNING: This page is about a different car, the 2015 Volkswagen Jetta. However, it is still accessible from the selected car via links, so may be relevant.

Install in reverse order of removal and note the following:

NOTE:

Do not clean the delivery module for the reducing agent with compressed air.

Clean all components and connections with water and a lint-free cloth.

All components must be dry before assembling.

Coat the seals with lubricant before installing.

Check the seals for damage.

-- Clean all components and connections with water and a lint-free cloth.

-- Replace the shock absorber. Refer to -item ) Shock Absorber-.

-- Replace the spacer sleeves. Refer to -item ) Spacer Sleeves-.

-- Replace the seals. Refer to -item ) Seal-.

-- Position the reducing agent delivery module and push in the mount without tilting.

-- Apply the necessary force fully.

-- Tighten the reducing agent delivery module to the tightening specification. Refer to Figure.

-- Adapt the adaptation value for the SCR system after draining reducing agent or replacing components. Refer to SELECTIVE CATALYTIC REDUCTION (SCR) SYSTEM ADAPTATION VALUE, ADAPTING .