LEMON Manuals: Even more car manuals for everyone
Home >> Volkswagen >> 2021 >> Jetta S, Automatic Trans >> Repair and Diagnosis >> External Pages >> Different car >> Section 26 (Exhaust System & Emission Controls System (Service Information - 2.0L - CVCA, CUUA, CUUB, DELA, DEBA, DEJA & DGMA)) >> 26 Exhaust System, Emission Controls >> Exhaust Temperature Regulation >> Exhaust Gas Temperature Sensor 2 -G448-, REMOVING AND INSTALLING >> Installing

Exhaust Gas Temperature Sensor 2 -G448-, REMOVING AND INSTALLING: Installing

WARNING: This page is about a different car, the 2015 Volkswagen Jetta. However, it is still accessible from the selected car via links, so may be relevant.

Install in reverse order of removal and note the following:

-- During installation, all cable ties must be installed at the same location.

CAUTION:

There is a risk of malfunctions from loose exhaust gas temperature sensor.

  • The thread on the Exhaust Gas Temperature Sensor 2 -G448- is coated. Do NOT coat with hot bolt paste and make sure to tighten to the tightening specification.
NOTE:

Protect the exhaust gas temperature sensor against knocks and impacts. A dropped exhaust gas temperature sensor may not be used again.

-- Note the electrical connections and routing. Refer to RELAY CARRIERS, FUSE PANELS AND E-BOXES , the appropriate WIRING DIAGRAM, and OVERVIEW - EXHAUST TEMPERATURE REGULATION .

-- Install the engine cover. Refer to ENGINE COVER, REMOVING AND INSTALLING .

scientia non olet · About LEMON Manuals