Exhaust Gas Temperature Sensor 1 -G235-, REMOVING AND INSTALLING: Installing

WARNING: This page is about a different car, the 2015 Volkswagen Jetta. However, it is still accessible from the selected car via links, so may be relevant.

Install in reverse order of removal and note the following:

-- During installation, all cable ties must be installed at the same location.

NOTE:

Protect the exhaust gas temperature sensor against knocks and impacts. A dropped exhaust gas temperature sensor may not be used again.

Coat the threads with hot bolt paste.

Exhaust Gas Temperature Sensor 1 -G235- installation position:

Courtesy of VOLKSWAGEN GROUP OF AMERICA, INC.

The angled shaft -1- goes downward vertically.

-- Note the electrical connections and routing. Refer to RELAY CARRIERS, FUSE PANELS AND E-BOXES and the appropriate WIRING DIAGRAM.

-- Install the engine cover. Refer to ENGINE COVER, REMOVING AND INSTALLING .