Front Exhaust Pipe, Removing And Installing: Installing

WARNING: This page is about a different car, the 2015 Volkswagen Jetta. However, it is still accessible from the selected car via links, so may be relevant.

Install in reverse order of removal and note the following:

-- Replace the seal after removal.

-- Pay attention that the screw-type clamp does not contact any component.

Installed location of the front exhaust pipe screw clamp. Refer to CLAMPING SLEEVE INSTALLATION POSITION .
Installed location of the seal between the emissions control module and front exhaust pipe. Refer to Seal Between The Emissions Control Module And Front Exhaust Pipe .

-- Install the exhaust system without tension. Refer to EXHAUST SYSTEM, INSTALLING WITHOUT TENSION .