Clamping Sleeve Installation Position: Procedure
WARNING: This page is about a different car, the 2015 Volkswagen Jetta. However, it is still accessible from the selected car via links, so may be relevant.
-- Install the clamping sleeve in the position shown.
- The threaded connection points to the right in the direction of travel.
- The threaded connection -arrows- must not project over the lower edge of the clamping sleeve.
- Pay attention to the installation position of the screw-type clamp. The clamp must not touch other components.
Installation dimension for vehicles with marking on the exhaust pipe
1 - Clamping Sleeve
2 - Exhaust Pipe
a - Installed Dimension
A - Exhaust System Marking
Installed dimension -a- for the clamping sleeve:
a - 8.5 mm
Version A - 25 Nm
Version B - 30 Nm
Tighten the threaded connections evenly.