Overview - Emissions Control System
WARNING: This page is about a different car, the 2015 Volkswagen Jetta. However, it is still accessible from the selected car via links, so may be relevant.
- Front Exhaust Pipe
- Removing and installing. Refer to FRONT EXHAUST PIPE, REMOVING AND INSTALLING .
- Exhaust System, Installing without Tension. Refer to EXHAUST SYSTEM, INSTALLING WITHOUT TENSION .
- Screw-Type Clamp
- 7 Nm
- Replace after removing.
- Seal
- Note the installation position. Refer to Seal Between The Emissions Control Module And Front Exhaust Pipe .
- Bolt
- Tightening specification and sequence. Refer to Figure.
- Seal
- Screw-Type Clamp
- Tightening specification and sequence. Refer to Figure.
- EGR Cooler
- Removing and installing. Refer to EGR COOLER, REMOVING AND INSTALLING .
- Checking for leaks. Refer to EGR COOLER, CHECKING FOR LEAKS .
- Bolt
- Tightening specification and sequence. Refer to Figure.
- Bolt
- Tightening specification and sequence. Refer to Figure.
- Bracket
- For the EGR cooler
- Screw-Type Clamp
- Tightening specification and sequence. Refer to Figure.
- Bolt
- Tightening specification and sequence. Refer to Figure.
- Turbocharger
- Removing and installing. Refer to TURBOCHARGER, REMOVING AND INSTALLING .
- Seal
- Place on the catalytic converter.
- Bracket
- For the emissions control module
- With lifter
- Preparing the lifter for installation. Refer to INSTALLING - CHECK THE LIFTERS -ARROW- FOR EASE OF MOVEMENT .
- Bolt
Tightening specification and sequence. Refer to Figure.
- Bolt
- Tightening specification and sequence. Refer to Figure.
- Bolt
- 9 Nm
- Metering Tube
- Union nut tightening specification: 45 Nm
- To the Differential Pressure Sensor -G505-
- Bolt
- Tightening specification and sequence. Refer to Figure.
- Bolt
- Tightening specification and sequence. Refer to Fig 2.
- Bracket
- For the emissions control module
- With lifters
- Preparing the lifters for installation. Refer to INSTALLING - CHECK THE LIFTERS -ARROW- FOR EASE OF MOVEMENT .
- Bolt
- Tightening specification and sequence. Refer to Fig 2.
- Emissions Control Module
- Particulate Filter with Catalytic Converter
- Removing and installing. Refer to EMISSIONS CONTROL MODULE, REMOVING AND INSTALLING .
- Bolt
- Tightening specification and sequence. Refer to Figure.
-- Tighten the bolts in steps according to the sequence:
| Step | Bolts | Tightening Specification |
|---|---|---|
| 1 | -3- | Install by hand all the way |
| 2 | -1- | 20 Nm |
| 3 | -3- | 20 Nm |