Cylinder Head, Sealing Surface, Resurfacing

WARNING: This page is about a different car, the 2015 Volkswagen Jetta. However, it is still accessible from the selected car via links, so may be relevant.

Courtesy of VOLKSWAGEN GROUP OF AMERICA, INC.

Reworking dimension, cylinder head:

-a- = minimum 132.6 mm

NOTE:

If the sealing surfaces are reworked, the valves must be set deeper at the same dimension. Rework the valve seat ring. Otherwise the valve will hit up against the pistons. Be careful not to exceed the minimum dimension. Refer to VALVE SEATS, REWORKING .