LEMON Manuals: Even more car manuals for everyone
Home >> Volkswagen >> 2021 >> Jetta S, Automatic Trans >> Repair and Diagnosis >> External Pages >> Different car >> Section 115 (Engine Mechanical (Cylinder Head & VALVETRAIN System - General & Service Information CBPA, CKJA)) >> 15 Cylinder Head, VALVETRAIN >> VALVETRAIN >> Camshaft, Removing And Installing >> Tightening Specifications

Tightening Specifications

WARNING: This page is about a different car, the 2015 Volkswagen Jetta. However, it is still accessible from the selected car via links, so may be relevant.
CAUTION:

Danger of causing damage to the pistons and the valves.

  • When turning camshaft, pistons may not be at TDC for any cylinder.

Assemble in reverse order of disassembly.

-- Install the toothed belt. Refer to TOOTHED BELT, REMOVING AND INSTALLING .

NOTE:

After installing new hydraulic valve lifters, the engine may not be started only after approximately 30 minutes. Hydraulic equalization elements must seat themselves. Otherwise the valves will impact the pistons.

scientia non olet · About LEMON Manuals