Overview - Toothed Belt

WARNING: This page is about a different car, the 2015 Volkswagen Jetta. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: Exploded View Of Toothed Belt

Courtesy of VOLKSWAGEN GROUP OF AMERICA, INC.

Bolt
- 45 Nm
Engine Support
Bolt
- Container bracket for power steering fluid; Tightening specification -item 3) OVERVIEW - CYLINDER BLOCK, BELT PULLEY SIDE - Bolt -.
- Belt pulley on pump; Tightening specification -item 3) OVERVIEW - CYLINDER BLOCK, BELT PULLEY SIDE - Bolt -.
Mount
- For the power steering fluid reservoir
Toothed Belt Guard Upper Section
Toothed Belt Guard Center Part
Nut/Bolt
- Nut tightening specification -item 7) OVERVIEW - CYLINDER BLOCK, BELT PULLEY SIDE - Nut/bolt -.
- Bolt tightening specification -item ) OVERVIEW - CYLINDER HEAD - Bolt-.
Washer
Tensioning Roller
- Checking the half automatic toothed belt tensioning roller. Refer to TOOTHED BELT DRIVE TENSIONER, CHECKING .
Toothed Belt
- Mark direction of travel before removing
- Check for wear
- Do not kink
- Removing and installing. Refer to TOOTHED BELT, REMOVING AND INSTALLING .
Rear Toothed Belt Guard
O-ring
- Replace after removing
Coolant Pump
- Check for ease of movement
- Replace completely if damaged or leaking
- Removing and installing. Refer to COOLANT PUMP, REMOVING AND INSTALLING .
Bolt
- 15 Nm
Crankshaft Toothed Belt Sprocket
Bolt
- 90 Nm +90°
- Replace after removing
Toothed Belt Guard Lower Section
Bolt
- 10 Nm
- Replace after removing
Belt Pulley
- For A/C compressor
Belt Pulley
- For power steering pump
Ribbed Belt
- Mark direction of travel before removing
- Check for wear
- Do not kink
- Removing and installing. Refer to RIBBED BELT, REMOVING AND INSTALLING .
Belt Pulley/Vibration Damper
- It is possible to install in one position only, the holes are offset asymmetrically.
- Note position when installing toothed belt. Refer to TOOTHED BELT, REMOVING AND INSTALLING .
Bolt
- 25 Nm
Ribbed Belt Tensioner
- To release tension on ribbed belt, pivot using a wrench. Refer to RIBBED BELT, REMOVING AND INSTALLING .