Valve Guides, Replacing: Installing

WARNING: This page is about a different car, the 2015 Volkswagen Jetta. However, it is still accessible from the selected car via links, so may be relevant.

-- Replace the valve guides and coat them with oil.

-- Press the guides from the camshaft side up to the collar in the cold cylinder head using the :3121 .

CAUTION:

After the guide with the collar is seated, the pressing force may not be increased over 10 kN. Otherwise the collar could break off.

-- Ream the valve guide using the :3120 .

Always use cutting oil for this.

-- Valve seats, reworking. Refer to VALVE SEATS, REWORKING .