Cylinder Head, Removing And Installing: Notes
WARNING: This page is about a different car, the 2015 Volkswagen Jetta. However, it is still accessible from the selected car via links, so may be relevant.
Special Tools And Workshop Equipment Required
- Instrument/Gauge Tester :VAG1306 or Shop Crane - Drip Tray :VAS6208
- Torque Wrench 1332 40-200Nm :VAG1332
- Hose Clip PliersVAS5024A
- Head Gasket Alignment Tool - Pins :3450/2A
- Head Gasket Alignment Tool - Rod :3450/3
- Wrench :3452 or Polydrive Bit Drive Socket :T10070
- Toothed Belt Tensioner :T10020
- Puller - Spark Plug Connector :T10112A
CAUTION:
This procedure contains mandatory replaceable parts. Refer to component overview and parts information prior to starting procedure.
Mandatory Replacement Parts
- Bolt - Cylinder Head to Cylinder Block
- Gasket - Cylinder Head to Cylinder Block
NOTE:
When using an exchanged cylinder head with camshaft installed, the contact surfaces between the lifters and cam lobes must be lubricated before installing the cylinder head cover.
The plastic protectors installed to protect the open valves must only be removed immediately before mounting the cylinder head.
All of the coolant must be changed if the cylinder head was replaced.
Intake manifold with fuel rail, removing and installing. Refer to INTAKE MANIFOLD WITH FUEL RAIL, REMOVING AND INSTALLING .
Conditions
- The engine must be no more than warm to touch.