LEMON Manuals: Even more car manuals for everyone
Home >> Volkswagen >> 2021 >> Jetta R-Line, Standard Trans >> Repair and Diagnosis >> External Pages >> Different car >> Section 66 (Crankshaft & Cylinder Block (General & Service Information - CVCA, CUUA, CUUB, DELA, DEBA, DEJA, DGMA)) >> 13 Crankshaft, Cylinder Block >> Cylinder Block, Belt Pulley Side >> Sub-Assembly Bracket, Removing And Installing >> Installing

Sub-Assembly Bracket, Removing And Installing: Installing

WARNING: This page is about a different car, the 2015 Volkswagen Jetta. However, it is still accessible from the selected car via links, so may be relevant.

Install in reverse order of removal and note the following:

NOTE:

Replace the bolts that were tightened with an additional turn after removing them.

-- Check if an alignment sleeve is between the sub-assembly bracket and the cylinder block.

scientia non olet · About LEMON Manuals