Camshaft Seal For Intake Camshaft, Removing And Installing, Belt Pulley Side: Installing

WARNING: This page is about a different car, the 2018 Volkswagen Jetta, 2017 Volkswagen Jetta, and 2016 Volkswagen Jetta. However, it is still accessible from the selected car via links, so may be relevant.

Courtesy of VOLKSWAGEN GROUP OF AMERICA, INC.

Do not coat the new seal with oil.

-- Slide the seal -1- over the :T10478/3 onto the :T10478/2 .

Installed position: the closed side of the seal faces the seal installer.

-- Separate the fitting sleeve and guide sleeve.

-- Mount the :T10478/2 with the seal -1- on the camshaft.

Courtesy of VOLKSWAGEN GROUP OF AMERICA, INC.

-- Install the seal with the :T10478/1A and the >>old<< bolt -1- for the camshaft sprocket all the way.

Courtesy of VOLKSWAGEN GROUP OF AMERICA, INC.

-- Installing camshaft adjuster. Refer to CAMSHAFT ADJUSTER, REMOVING AND INSTALLING .