Overview - Cylinder Block, Transmission Side: Notes

WARNING: This page is about a different car, the 2015 Volkswagen Jetta. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: Exploded View Of Cylinder Block, Transmission Side

Courtesy of VOLKSWAGEN GROUP OF AMERICA, INC.

Bolt
- 60 Nm +90°
- Replace after removing.
Flywheel
- Removing and installing. Refer to FLYWHEEL, REMOVING AND INSTALLING .
- Only possible to install in one position
Sensor Wheel
- For the Engine Speed Sensor -G28-
- Removing and installing. Refer to SEALING FLANGE, REMOVING AND INSTALLING, TRANSMISSION SIDE .
Engine Speed Sensor -G28-
- Overview. Refer to OVERVIEW - GLOW PLUG SYSTEM .
Bolt
- Tightening specification. Refer to OVERVIEW - GLOW PLUG SYSTEM
Alignment Pin
- Quantity: 2
Intermediate Plate
- Be careful not to damage or bend it when installing.
- Installing. Refer to Installing Intermediate Flange .
Transmission Side Sealing Flange
- Replace after removing. Refer to SEALING FLANGE, REMOVING AND INSTALLING, TRANSMISSION SIDE .
- With shaft seal
Bolt
- Tightening specification and sequence. Refer to Transmission Side Side Sealing Flange Tightening Specifications And Sequence .