LEMON Manuals: Even more car manuals for everyone
Home >> Volkswagen >> 2021 >> Jetta R-Line, Automatic Trans >> Repair and Diagnosis >> External Pages >> Different car >> Section 66 (Crankshaft & Cylinder Block (General & Service Information - CVCA, CUUA, CUUB, DELA, DEBA, DEJA, DGMA)) >> 13 Crankshaft, Cylinder Block >> Cylinder Block, Transmission Side >> Flywheel, Removing And Installing >> Removing

Flywheel, Removing And Installing: Removing

WARNING: This page is about a different car, the 2015 Volkswagen Jetta. However, it is still accessible from the selected car via links, so may be relevant.
GWWA30-0102Courtesy of VOLKSWAGEN GROUP OF AMERICA, INC.
CAUTION:

Risk of destroying the flywheel.

  • Remove the bolts -B- by hand. Do not use an air-powered or impact wrench.
  • When removing the bolts, make sure that the bolt head does not come in contact with the flywheel.
  • Turn the flywheel -A- so that the bolts -B- line up with the center of the holes -arrows-.

-- Insert the :3067  into the hole on the cylinder block -B- and loosen the flywheel bolts.

GWWN13-10563Courtesy of VOLKSWAGEN GROUP OF AMERICA, INC.

-- Remove the bolts and the flywheel.

scientia non olet · About LEMON Manuals