Vibration Damper, Removing And Installing: Installing
WARNING: This page is about a different car, the 2015 Volkswagen Jetta. However, it is still accessible from the selected car via links, so may be relevant.
Install in reverse order of removal and note the following:
- Installed position: the hole in the vibration damper crankshaft -arrow- must be positioned over the raised section on the crankshaft toothed belt sprocket.
NOTE:
Replace the bolts that were tightened with an additional turn after removing them.
-- Install the ribbed belt. Refer to RIBBED BELT, REMOVING AND INSTALLING .