Engine Support, Removing And Installing: Installing

WARNING: This page is about a different car, the 2015 Volkswagen Jetta. However, it is still accessible from the selected car via links, so may be relevant.

Install in reverse order of removal and note the following:

-- Install the bolt -2- before installing the engine support in the engine support hole.

-- Mount the engine support and tighten the bolts -1 through 3- hand-tight.

Courtesy of VOLKSWAGEN GROUP OF AMERICA, INC.

-- Tighten the bolts as follows to the specified tightening specification and sequence. Refer to the figure below;

Courtesy of VOLKSWAGEN GROUP OF AMERICA, INC.

-- Install the upper toothed belt guard. Refer to TOOTHED BELT GUARD, REMOVING AND INSTALLING .

-- Install the engine mount. Refer to ENGINE MOUNT, REMOVING AND INSTALLING .