Overview - Toothed Belt Guard
WARNING: This page is about a different car, the 2015 Volkswagen Jetta. However, it is still accessible from the selected car via links, so may be relevant.
- Lower Toothed Belt Guard
- Removing and installing. Refer to LOWER TOOTHED BELT GUARD, REMOVING AND INSTALLING .
- Bolt
- 12 Nm
- With collar
- Mounted permanently in the lower toothed belt guard
- Bracket
- For coolant lines
- Bolt
- 5 Nm
- Pipe
- To the Differential Pressure Sensor -G505-
- Clip
- Bolt
- 5 Nm
- Bracket
- For coolant lines and SCR lines
- Heat Shield
- Bolt
- 5 Nm
- Bracket
- For the measuring tube
- Upper Toothed Belt Guard
- Removing and installing. Refer to TOOTHED BELT GUARD, REMOVING AND INSTALLING .
- Bolt
- 12 Nm
- Install with locking fluid.
- Rear Toothed Belt Guard
- For the removal, remove the coolant pump. Refer to COOLANT PUMP, REMOVING AND INSTALLING .