Fuel Injector Seals, Removing And Installing: Procedure
WARNING: This page is about a different car, the 2015 Volkswagen Jetta. However, it is still accessible from the selected car via links, so may be relevant.
-- Remove the corresponding fuel injector. Refer to OVERVIEW - FUEL INJECTORS .
-- Install the :T40195 into the gasket -1-.
-- Attach the :T10133/3 to the seal puller with the :T10133/2 as shown in the illustration and remove it by tapping it upward.
-- Install the new fuel injector seal with the :3390 and short extension -1- all the way and from above.