Overview - Oil Pan/Oil Pump
WARNING: This page is about a different car, the 2023 Volkswagen Atlas. However, it is still accessible from the selected car via links, so may be relevant.
NOTE:
If large quantities of metal particles or other deposits such as those caused by partial seizure of the crankshaft or connecting rod damage are found in the engine oil, clean the oil channels thoroughly and replace the engine oil cooler to prevent subsequent damage.
- Nut
- 9 Nm
- Oil Level Thermal Sensor -G266-
- Removing and Installing. Refer to Oil Level Thermal Sensor -G266-, REMOVING AND INSTALLING .
- O-Ring
- Coat with engine oil
- Replace after removing
- Oil Drain Plug
- 30 Nm
- Seal
- Replace the gasket after removal
- Sealant
- Silicone Sealant. Refer to the appropriate Electronic Parts Information.
- Bolt
- For the oil baffle and oil intake pipe
- Replace after removing
- 4 Nm +45°
- Oil Baffle
- If the oil pan upper section is replaced, the oil baffle must also be replaced.
- O-Ring
- Coat with engine oil
- Replace after removing
- Oil Intake Pipe
- Clean the screen if there are debris
- Centering Bracket
- Bolt
- Replace after removing
- Tightening sequence. Refer to Fig 2.
- Oil Pan Upper Section
- Removing and Installing. Refer to OIL PAN UPPER SECTION, REMOVING AND INSTALLING .
- Tightening sequence. Refer to Fig 2.
- If the oil pan upper section is replaced, the oil baffle must also be replaced.
- Cylinder Block
- Oil Pump Drive Chain
- Mark the running direction before removal
- Bolt
- 9 Nm
- Chain Tensioner
- O-Ring
- Coat with engine oil
- Replace after removing
- Oil Pressure Regulation Valve -N428-
- Removing and Installing. Refer to Oil Pressure Regulation Valve -N428-, REMOVING AND INSTALLING .
- Bolt
- Tightening specification OVERVIEW - OIL PRESSURE SWITCH/OIL PRESSURE REGULATION.
- Oil Screen
- Oil Pump
- Removing and Installing. Refer to OIL PUMP, REMOVING AND INSTALLING .
- Oil Pump Bolt
- Replace after removing
- 8 Nm +90°
- O-Ring
- Coat with engine oil
- Replace after removing
- Oil Intake Pipe Bolt
- Replace after removing
- 4 Nm +45°
- Oil Pan Bolt
- Replace after removing
- Tightening sequence. Refer to OIL PAN LOWER SECTION, REMOVING AND INSTALLING .
- Oil Pan Lower Section
- Removing and Installing. Refer to OIL PAN LOWER SECTION, REMOVING AND INSTALLING .
Oil Pan Upper Section - Tightening Specifications and Sequence
- Replace the bolts after removing them.
- Always use 18 bolts.
-- Tighten the bolts -1 through 18- in the sequence shown.
| Step | Bolts | Tightening specification/additional turn |
|---|---|---|
| 1. | -1 through 18- | 8 Nm |
| 2. | -1 and 2- | 180° additional turn |
| 3. | -3 to 13- | 45° additional turn |
| 4. | -14 through 18- | 90° additional turn |