Connecting Rods, Checking Radial Clearance
WARNING: This page is about a different car, the 2023 Volkswagen Atlas. However, it is still accessible from the selected car via links, so may be relevant.
Special tools and workshop equipment required
- Plastigage
Procedure
-- Remove the connecting rod bearing cap.
-- Clean the bearing cap and pin.
-- Place the plastigage over the entire width of the bearing journal or into the bearing shells.
-- Position the connecting rod bearing cap and tighten the old bolts OVERVIEW - PISTONS AND CONNECTING ROD without turning the crankshaft.
-- Remove the connecting rod bearing cap again.
-- Compare the width of Plastigage with the measuring scale.
Radial clearance:
- New: 0.02 to 0.06 mm.
- Wear limit: 0.09 mm.
-- Replace the connecting rod bolts.