Engine Support, Removing And Installing: Installing

WARNING: This page is about a different car, the 2023 Volkswagen Atlas. However, it is still accessible from the selected car via links, so may be relevant.

Install in the reverse order of removal while noting the following:

Engine Support - Tightening Specification and Sequence

Fig 1: Engine Support - Tightening Sequence

Courtesy of VOLKSWAGEN GROUP OF AMERICA, INC.

NOTE:

Replace the bolts.

-- Tighten the bolts in the steps in the sequence shown:

Step	Bolts	Tightening Specification/Additional Turn
1.	-1 to 3-	7 Nm
2.	-1 to 3-	40 Nm
3.	-1 to 3-	90° additional turn

-- Install the engine mount. Refer to ENGINE MOUNT, REMOVING AND INSTALLING .