LEMON Manuals: Even more car manuals for everyone
Home >> Volkswagen >> 2021 >> Golf Standard Trans >> Repair and Diagnosis >> External Pages >> Different car >> Section 21 (Lubrication (4-Cylinder Direct Injection (1.8L; 2.0L, 4V, Turbocharger, Chain Drive, Ea888, Generation III))) >> 17 Lubrication >> Oil Pan/Oil Pump >> Oil Level Thermal Sensor -G266-, REMOVING AND INSTALLING >> Removing

Oil Level Thermal Sensor -G266-, REMOVING AND INSTALLING: Removing

WARNING: This page is about a different car, the 2021 Volkswagen GTI, 2020 Volkswagen GTI, 2019 Volkswagen GTI, 2018 Volkswagen Golf, and 2018 Volkswagen GTI. However, it is still accessible from the selected car via links, so may be relevant.

-- Drain the engine oil. Refer to ENGINE OIL, DRAINING, REPLACING OIL FILTER, AND FILLING .

-- Remove the noise insulation. Refer to OVERVIEW - NOISE INSULATION .

-- Disconnect the connector -3-.

Fig 1: Identifying Oil Level Thermal Sensor
GWWN17-10356Courtesy of VOLKSWAGEN GROUP OF AMERICA, INC.

-- Remove the nuts -1- and the Oil Level Thermal Sensor -G266- -4-.

scientia non olet · About LEMON Manuals