LEMON Manuals: Even more car manuals for everyone
Home >> Volkswagen >> 2021 >> Golf Standard Trans >> Repair and Diagnosis >> External Pages >> Different car >> Section 20 (Cylinder Head, VALVETRAIN (4-Cylinder Direct Injection (1.8L; 2.0L, 4V, Turbocharger, Chain Drive, Ea888, Generation III))) >> 15 Cylinder Head, VALVETRAIN >> Cylinder Head >> Vacuum Pump, Removing And Installing >> Installing

Vacuum Pump, Removing And Installing: Installing

WARNING: This page is about a different car, the 2021 Volkswagen GTI, 2020 Volkswagen GTI, 2019 Volkswagen GTI, 2018 Volkswagen Golf, and 2018 Volkswagen GTI. However, it is still accessible from the selected car via links, so may be relevant.
Fig 1: Locating Bolts And Vacuum Pump
GWWA47-10091Courtesy of VOLKSWAGEN GROUP OF AMERICA, INC.

-- Clean the sealing surfaces.

-- Turn the vacuum pump coupling plate so that it engages in the camshaft groove when installing the vacuum pump.

-- Position the new seal on the vacuum pump and insert the two bolts. Position the vacuum pump with the seal on the cylinder head.

-- While doing so pay attention that it lays flush on the flange.

Further assembly is performed in the reverse order of the removal.

scientia non olet · About LEMON Manuals