Overview - Radiator/Coolant Fan
WARNING: This page is about a different car, the 2021 Volkswagen GTI, 2020 Volkswagen GTI, 2019 Volkswagen GTI, 2018 Volkswagen Golf, and 2018 Volkswagen GTI. However, it is still accessible from the selected car via links, so may be relevant.
- Coolant Hose
- Lift the retaining clamp to remove
- Connecting. Refer to Fig 2
- O-Ring
- Replace after removing
- Coat with coolant
- Engine Coolant Temperature Sensor on Radiator Outlet -G83-
- Removing and installing. Refer to Engine Coolant Temperature Sensor on Radiator Outlet -G83-, REMOVING AND INSTALLING .
- Radiator
- Removing and installing. Refer to RADIATOR, REMOVING AND INSTALLING .
- Change the coolant after replacing
- Coolant Hose
- Lift the retaining clamp to remove
- Connecting. Refer to Fig 2
- O-Ring
- Replace after removing
- Coat with coolant
- Charge Air Cooler
- Removing and installing. Refer to CHARGE AIR COOLER, REMOVING AND INSTALLING .
- Air Guide
- Air Guide
- Radiator Mount
- Condenser
- Removing and installing. Refer to CONDENSER, REMOVING AND INSTALLING .
- Rubber Bushing
- For the charge air cooler
- O-Ring
- Replace after removing
- Coat with coolant
- Clamp
- For Engine Coolant Temperature Sensor on Radiator Outlet -G83-
Connect the Coolant Hose to the Coupling
-- Remove the old O-ring -2- in the coolant hose -3-.
-- Coat the new O-ring with coolant and insert it in the coolant hose.
-- Press the coolant hose on to the coolant pipe -1- until you hear it engage.
-- Press the coolant hose on again and pull to make sure the connection is engaged correctly.