Vibration Damper, Removing And Installing: Installing

Fig 1: View Of Loosening Bolt For Vibration Damper By Using Counterhold - Pulley - T10475-

Courtesy of VOLKSWAGEN GROUP OF AMERICA, INC.

-- Replace the bolts that were tightened with an additional turn.

-- All surfaces between the bolt, vibration damper and crankshaft toothed belt sprocket must not have any oil or grease on them.

-- Install the vibration damper and install the vibration damper bolt, with an oiled thread, all the way in by hand.

-- Tighten the bolt -arrow- for the vibration damper by using the : T10475 .

Further installation is performed in reverse order of removal, while noting the following:

-- Install the ribbed belt. Refer to RIBBED BELT, REMOVING AND INSTALLING .

Tightening Specifications