LEMON Manuals: Even more car manuals for everyone
Home >> Volkswagen >> 2021 >> Golf Standard Trans >> Repair and Diagnosis >> Engine Mechanical >> Blowers, Superchargers & Turbochargers >> Turbocharger, Supercharger (4-Cylinder Direct Fuel Injection (1.4L Engine, 4V, Ea211, Turbocharger)) >> 21 Turbocharger, Supercharger >> Turbocharger >> Charge Air Pressure Actuator -V465-, REMOVING AND INSTALLING >> Charge Air Pressure Actuator -V465-, REMOVING AND INSTALLING, VERSION 1 >> Installing

Charge Air Pressure Actuator -V465-, REMOVING AND INSTALLING, VERSION 1: Installing

Install in reverse order of removal and note the following:

Replace bolts and clips.

Charge Air Pressure Actuator -V465- without Adjustable Linkage

-- Adapt the Engine Control Module -J623- to the Charge Air Pressure Actuator -V465- using the Vehicle Diagnostic Tester Guided Functions  .

Charge Air Pressure Actuator -V465- with Adjustable Linkage

-- Install the thread of the Charge Air Pressure Actuator -V465- into the joint in the center position.

-- Adjust the Charge Air Pressure Actuator -V465- using the Vehicle Diagnostic Tester by selecting 01 - Charge Air Pressure Actuator V465, Adjusting  in Guided Functions  .

-- Turn the linkage to adjust the specified value. For the specified value, use the Vehicle Diagnostic Tester.

-- Tighten the lock nut to 6 Nm and secure with sealing wax.

scientia non olet · About LEMON Manuals