Lock Cylinder, Removing And Installing: Installing
Install in reverse order of removal and note the following:
-- Insert the ignition key into the lock cylinder and turn it to the ignition "on" position.
-- Slide the :T40011 or a suitable welding wire all the way into the front hole again.
-- Connect the connector to the Anti-Theft Immobilizer Reader Coil -D2-.
-- Push in the lock cylinder -1- with the Anti-Theft Immobilizer Reader Coil -D2- in the steering lock housing -3-.
-- Remove the :T40011 from the hole -2-.
-- Push the lock cylinder in firmly until the locking mechanism engages audibly.