Left And Right Headlamp Power Output Module -J667- / -J668-, Removing And Installing: Installing

Install in reverse order of removal and note the following:

-- Check the seal between the Left Headlamp Power Output Module -J667- and the headlamp housing for damage.

CAUTION:

There is a risk of damaging the headlamp.

Make sure the seal fits correctly when installing the Left Headlamp Power Output Module -J667-. Water getting in the headlamp will cause damage.

NOTE:

If a new LED Headlamp Power Output Module A32/A27 is installed, the control module replacing function and the "initial operation" function, must be performed in the guided functions or guided fault finding.

-- Perform a function test.

-- Check the headlamp adjustment and adjust the headlamp if necessary.