LEMON Manuals: Even more car manuals for everyone
Home >> Volkswagen >> 2021 >> Golf Automatic Trans >> Repair and Diagnosis >> External Pages >> Different car >> Section 7 (Turbocharger, Supercharger (4-Cylinder Direct Injection (1.8L; 2.0L, 4V, Turbocharger, Chain Drive, Ea888, Generation III))) >> 21 Turbocharger, Supercharger >> Charge Air System >> Air Duct Pipe, Removing And Installing >> Air Duct Pipe From Turbocharger To Charge Air Cooler, Removing And Installing >> Removing

Air Duct Pipe From Turbocharger To Charge Air Cooler, Removing And Installing: Removing

WARNING: This page is about a different car, the 2021 Volkswagen GTI, 2020 Volkswagen GTI, 2019 Volkswagen GTI, 2018 Volkswagen Golf, and 2018 Volkswagen GTI. However, it is still accessible from the selected car via links, so may be relevant.

-- Remove the noise insulation. Refer to OVERVIEW - NOISE INSULATION .

-- Loosen the hose clamps -arrows- and remove the left charge air hose -A-.

Fig 1: Removing Change Air Hose
GWWN15-10703Courtesy of VOLKSWAGEN GROUP OF AMERICA, INC.

-- Free up the wiring harness -1 and 2-.

GWWN21-10970Courtesy of VOLKSWAGEN GROUP OF AMERICA, INC.

-- Remove the bolt -3-.

-- Remove the air filter housing. Refer to AIR FILTER HOUSING, REMOVING AND INSTALLING .

-- Free up the wiring harness -1- from the air duct pipe.

GWWN21-10969Courtesy of VOLKSWAGEN GROUP OF AMERICA, INC.

-- Loosen the screw-type clamp -2-.

-- Remove the screw -3-.

-- Remove the air duct pipe -4- upward.