LEMON Manuals: Even more car manuals for everyone
Home >> Volkswagen >> 2021 >> Golf Automatic Trans >> Repair and Diagnosis >> External Pages >> Different car >> Section 19 (Crankshaft, Cylinder Block (4-Cylinder Direct Injection (1.8L; 2.0L, 4V, Turbocharger, Chain Drive, Ea888, Generation III))) >> 13 Crankshaft, Cylinder Block >> Piston And Connecting Rod >> Pistons, Removing And Installing >> Installing

Pistons, Removing And Installing: Installing

WARNING: This page is about a different car, the 2021 Volkswagen GTI, 2020 Volkswagen GTI, 2019 Volkswagen GTI, 2018 Volkswagen Golf, and 2018 Volkswagen GTI. However, it is still accessible from the selected car via links, so may be relevant.

Install in reverse order of removal. Note the following:

NOTE:

Replace the bolts were tightened with an additional turn.

Arrow on piston face points toward belt pulley side.

Offset the piston ring gap by 120°.

-- Coat the contact surfaces on the bearing shells with oil.

-- Install the piston with a piston ring compressor. Pay attention to the installed position -item  ) Piston.

-- Install the connecting rod bearing cap. Pay attention to the installed position -item  ) Connecting Rod Bearing Cap.

-- Install the cylinder head. Refer to CYLINDER HEAD, REMOVING AND INSTALLING .

-- Install the oil pan upper section. Refer to OIL PAN UPPER SECTION, REMOVING AND INSTALLING .

scientia non olet · About LEMON Manuals