LEMON Manuals: Even more car manuals for everyone
Home >> Volkswagen >> 2021 >> Golf Automatic Trans >> Repair and Diagnosis >> External Pages >> Different car >> Section 19 (Crankshaft, Cylinder Block (4-Cylinder Direct Injection (1.8L; 2.0L, 4V, Turbocharger, Chain Drive, Ea888, Generation III))) >> 13 Crankshaft, Cylinder Block >> Cylinder Block, Transmission Side >> Flywheel, Removing And Installing >> Removing

Flywheel, Removing And Installing: Removing

WARNING: This page is about a different car, the 2021 Volkswagen GTI, 2020 Volkswagen GTI, 2019 Volkswagen GTI, 2018 Volkswagen Golf, and 2018 Volkswagen GTI. However, it is still accessible from the selected car via links, so may be relevant.
Fig 1: Identifying Dual-Mass Flywheel & Bolts
GWWA30-0102Courtesy of VOLKSWAGEN GROUP OF AMERICA, INC.
NOTE:

Remove the bolts -B- by hand. Do not use an air-powered or impact wrench.

When removing bolts, ensure bolt head does not come in contact with the flywheel.

Turn the flywheel -A- until the bolts -B- line up with the holes -arrows-.

Fig 2: Identifying Flywheel Retainer
GWWN13-10563Courtesy of VOLKSWAGEN GROUP OF AMERICA, INC.

-- Insert the : 3067  into the hole in the cylinder block -B-.

-- Loosen and remove bolts for flywheel.

scientia non olet · About LEMON Manuals