LEMON Manuals: Even more car manuals for everyone
Home >> Volkswagen >> 2021 >> Golf Automatic Trans >> Repair and Diagnosis >> External Pages >> Different car >> Section 19 (Crankshaft, Cylinder Block (4-Cylinder Direct Injection (1.8L; 2.0L, 4V, Turbocharger, Chain Drive, Ea888, Generation III))) >> 13 Crankshaft, Cylinder Block >> Cylinder Block, Belt Pulley Side >> Ribbed Belt TENSIONER, Removing And Installing >> Removing

Ribbed Belt TENSIONER, Removing And Installing: Removing

WARNING: This page is about a different car, the 2021 Volkswagen GTI, 2020 Volkswagen GTI, 2019 Volkswagen GTI, 2018 Volkswagen Golf, and 2018 Volkswagen GTI. However, it is still accessible from the selected car via links, so may be relevant.

-- Remove the ribbed belt from the tensioner. Refer to RIBBED BELT, REMOVING AND INSTALLING .

-- Remove the bolts -arrows- and pull the ribbed belt tensioning damper -1- off the sub-assembly bracket.

Fig 1: Drive Belt Tensioning Damper
GWWA13-10906Courtesy of VOLKSWAGEN GROUP OF AMERICA, INC.
scientia non olet · About LEMON Manuals