Engine Support, Removing And Installing: Removing

WARNING: This page is about a different car, the 2021 Volkswagen GTI, 2020 Volkswagen GTI, 2019 Volkswagen GTI, 2018 Volkswagen Golf, and 2018 Volkswagen GTI. However, it is still accessible from the selected car via links, so may be relevant.

Special tools and workshop equipment required

Engine Support Bridge - Spindle: 10-222A/11

-- Remove the engine bracket. Refer to ENGINE MOUNT, REMOVING AND INSTALLING .

-- Lift the engine using the : 10-222A/11 -1- to dimension -a-.

Fig 1: Identifying Engine Support Bridge - Spindle 10 - 222 A /11

Courtesy of VOLKSWAGEN GROUP OF AMERICA, INC.

Dimension -a- = approximately 30 mm.

-- Remove the bolts -1, 2 and 3- and engine support.

Courtesy of VOLKSWAGEN GROUP OF AMERICA, INC.