LEMON Manuals: Even more car manuals for everyone
Home >> Volkswagen >> 2021 >> Golf Automatic Trans >> Repair and Diagnosis >> External Pages >> Different car >> Section 19 (Crankshaft, Cylinder Block (4-Cylinder Direct Injection (1.8L; 2.0L, 4V, Turbocharger, Chain Drive, Ea888, Generation III))) >> 13 Crankshaft, Cylinder Block >> Cylinder Block, Belt Pulley Side >> Engine Support, Removing And Installing >> Installing

Engine Support, Removing And Installing: Installing

WARNING: This page is about a different car, the 2021 Volkswagen GTI, 2020 Volkswagen GTI, 2019 Volkswagen GTI, 2018 Volkswagen Golf, and 2018 Volkswagen GTI. However, it is still accessible from the selected car via links, so may be relevant.

Install in reverse order of removal. Note the following:

-- Install the engine mount. Refer to ENGINE MOUNT, REMOVING AND INSTALLING .

Engine Support - Tightening Specification and Sequence 

GWWA10-11481Courtesy of VOLKSWAGEN GROUP OF AMERICA, INC.
NOTE:

Replace the bolts.

-- Tighten the bolts in steps in the sequence shown:

Step Bolts Tightening Specification/Additional Turn
1. -1 to 3- 7 Nm
2. -1 to 3- 40 Nm
3. -1 to 3- Tighten an additional 90°
scientia non olet · About LEMON Manuals